Keeping flat stock locked down on a CNC router or machining center is a constant battle between clamps, toolpaths, and cleanup. A vacuum table solves that by pulling the workpiece against a flat, sealed surface. The Vacuum Table for CNC Machining single sided Machinable Delrin, Can Resurface is a compact 14-inch x 22-inch option designed to be machined again after use, and the main question is whether it fits your parts and your existing vacuum setup.
Quick verdict
This CNC vacuum table is for someone who works with flat pieces smaller than 14 inches x 22 inches and already has an air compressor or vacuum generator. The Delrin top is used, but because it can be resurfaced, you have a way to clean up the face before you put it into service. At USD 89.98, it's a direct way to try vacuum workholding without committing to a large production table.
Who it suits
Buyers who cut sheet material, engrave flat blanks, or run small repeat jobs will get the most from this table. The resurfaceable machinable surface works well when you need one reliable work plane and don't mind surfacing it occasionally. It's less suited as a large-format spoilboard for full sheets.
What stands out from the listed details
The 2-inch-thick Delrin construction gives the table enough body to be fixed to a machine bed. The 1/4 NPT inlet fitting hole lets you connect to a shop vacuum line or vacuum generator, and the corner stops make it easier to seat a workpiece in the same place repeatedly. The real standout is the resurfacing option: if the used face has tool marks, a light cleanup pass can restore flatness.
Meaningful trade-offs
The main trade-off is size. A 14-inch x 22-inch area supports smaller panels, not full sheets. The table is also single-sided, so you only get one working face; there is no second side to flip to as it wears. The unit is used, which is worth factoring into your expectations, and the resurfacing feature is the specific reason that matters less. Finally, this is only the table; you still need a vacuum source and fitting to make it work.
Bottom line
If your workpieces fit the working area and you already have a vacuum generator or air compressor, this is a functional way to get into vacuum clamping. The used condition and single-sided design are worth weighing, but the machinable and resurfaceable Delrin top gives you a clear path to keep the table flat over time. For a small CNC setup, that combination of simplicity and repairability makes it a sensible pick.
Vacuum Table for CNC Machining single sided Machinable Delrin, Can Resurface
At USD 89.98, this Delrin table offers a 14-inch x 22-inch work surface, a 1/4 NPT inlet fitting hole, corner stops, and a single-sided top that can be resurfaced. The reason to choose it is the ability to machine the top flat again when it picks up cutter marks. The limitation is the same single-sided design: it offers only one working face, and it needs an external vacuum source to generate holding force.
