Choosing between a used Koike Aronson CNC Plasma Cutter-II-510 with a 5' x 10' table and a new Everlast PowerPlasma 82i 80-amp CNC-capable plasma cutter comes down to a classic decision: buy a complete large-format system or start with a flexible new machine. In the laser plasma waterjet cutting category, these two options sit at very different ends of the price scale, and each one changes how you'll set up your workflow.
Quick verdict
The choice comes down to whether you want a complete table system or a new cutter you can build around. The price gap is $10,083.50, so your budget will likely decide the direction. If you already have a table or want to create your own setup, the PowerPlasma 82i is the more approachable buy. If you want a ready-to-run CNC cutting package with a 5' x 10' table, the Koike Aronson Cutter-II-510 is the complete system-but you're paying for that table and a 2005 used machine.
Comparison table
| Consideration | Koike Aronson Cutter-II-510 | Everlast PowerPlasma 82i |
|---|---|---|
| Price | $11,442.50 | $1,359.00 |
| Price bar | ||
| Condition | Used | New |
| Model / Year | Cutter-II-510, 2005 | PowerPlasma82i |
| Key specs | 5' x 10' cutting table | 80 Amps, 1 Phase, IPT-80 torch |
Where each product wins
Koike Aronson Cutter-II-510 wins if: you need a large 5' x 10' cutting table as part of the CNC plasma system, and you're comfortable buying a used machine from 2005.
Everlast PowerPlasma 82i wins if: you want a new, CNC-capable 80-amp cutter with a digital control package and the IPT-80 torch, and you prefer to build or supply your own table and workholding.
Product notes
Koike Aronson CNC Plasma Cutter-II-510
If your shop can absorb the $11,442.50 price, this used Koike Aronson setup is the most complete way to get into large-format CNC plasma cutting. The 5' x 10' table is the centerpiece, and the Cutter-II-510 model is built for precision plasma operations. The machine was manufactured in 2005, so you're buying a used system rather than a new unit. That's the main limitation: it's a used machine. The package also carries a significantly higher initial price than the PowerPlasma, so it's a bigger commitment. But if you need a big table with the cutter already integrated, this is the direction to go.
Everlast PowerPlasma 82i
For $1,359, the PowerPlasma 82i gives you a new, CNC-capable 80-amp plasma cutter with digital controlled circuitry and a digital air pressure gauge. The 1-phase input is a concrete spec to compare with your available power, and the IPT-80 torch is included. It's a much lighter investment than the Koike, so if you're starting out or prefer to build your own cutting table, this is a flexible route. The package focuses on the cutter and torch; if you don't already have a table, that becomes a separate consideration. The main limitation is the 1-phase power input, so if your shop is wired only for three-phase power, you'll need to address that before installation.
Final choice by use case
Choose the Koike Aronson Cutter-II-510 if you need a large 5' x 10' cutting table and prefer a used, fully integrated CNC plasma system. Choose the Everlast PowerPlasma 82i if you want a new, CNC-capable 80-amp cutter, have your own table or fabrication setup in mind, and want to keep your initial investment lower.
