Choosing a plasma cutter for a busy fabrication shop means balancing cutting amperage, power input, and how easily the unit will fit into a CNC setup. The PowerEdge120 plasma cutter addresses that balance directly: it combines a serious cutting current with a blowback torch that is ready for CNC table operation.
Quick verdict
The PowerEdge120 is a dedicated 120-amp, 440-volt three-phase machine listed at USD 3,999.00. It is designed for shops that already run industrial power and want a straight torch for CNC table use, while still including a handheld cable for manual work. If your checklist includes CNC integration, a blowback non-HF torch design, and a full set of torch consumables, this unit deserves a close look.
Who it suits
This cutter suits fabricators who want one machine that can step between CNC table operation and handheld cutting. The unit includes a straight CNC torch with CNC cable and a handheld cable, so the PowerEdge120 is positioned for both setups. It is best for industrial environments where a heavier power feed is available. It also suits operators who want a torch design that reduces the high-frequency interference that can disrupt CNC control signals.
What stands out
A 120-amp capacity is the core draw: this is a high-current machine for demanding metal-cutting work. The package includes a remote control and remote cable, an air regulator, a hose, a ground clamp with cable, ten plasma torch consumables, two 26ft torch cable setups, and a CNC cable. That breadth of included parts removes some of the usual setup purchases. The unit is CNC table ready for the GOFABCNC table, and for other CNC tables a specific control cable can be arranged. The machine is a blowback, non-HF design, and it carries a five-year warranty.
Meaningful trade-offs
The three-phase power requirement is the biggest constraint. If you do not have that power available, this is not the machine for you. CNC integration with a non-GOFAB table may require extra steps: the control cable needs to be matched to your table controller, so a custom connection may be part of your setup. The included straight torch is intended for CNC use, so if you plan to switch between handheld and table work, the handheld cable is provided, but you will have two separate torch assemblies to manage.
Product note
PowerEdge120 Plasma Cutter 120Amps, 3phase 440V, CNC table ready! (Blowback)
At USD 3,999.00, this is an industrial plasma cutter with a straight CNC torch plus a handheld cable. The included consumables and ground clamp make it a more complete package than a bare cutter. The limitation is the power input needed and the fact that CNC connection with tables other than GOFAB may require a custom cable.
Bottom line
The PowerEdge120 plasma cutter is a strong option if your shop already runs industrial power and you want a CNC-ready machine with handheld capability built into one purchase. The package includes both torch setups and consumables. The trade-off to weigh most heavily is the power input requirement and the possible custom cable need for non-GOFAB CNC tables. If those align with your shop, this is a compelling machine.
