Choosing a power feed for your milling machine comes down to one practical question: which axis do you need to automate? In the world of lathes, mills, and drilling machines, these two power feeds-the Uimoso Z-Axis and the VEVOR X-Axis-look close on paper. Both list 450 in-lb torque, a 0-200 RPM speed range, 965 mm/min feed rate, 1,385 mm/min return speed, and a 5/8" spindle fit. With that much overlap, the axis each unit is named for becomes the deciding factor.
Quick Verdict
If you're driving the Z-axis of a milling machine, the Uimoso is the direct match. If you need X-axis automation, the VEVOR is the one. The price gap is small-$134.99 for the Uimoso versus $139.90 for the VEVOR-so axis compatibility, not price, should settle this.
Listed Price and Key Specs at a Glance
| Product | Listed Price | Price Bar | Max Torque | Max Speed | Max Feed Rate | Max Return Speed | Spindle Diameter | Net Weight | Model |
|---|---|---|---|---|---|---|---|---|---|
| Uimoso Z-Axis Power Feed | USD 134.99 | 450 in-lb | 200 RPM | 965 mm/min | 1,385 mm/min | 5/8" | 12.57 lbs | AL-450 | |
| VEVOR X-Axis Power Feed | USD 139.90 | 450 in-lb | 200 RPM | 965 mm/min | 1,385 mm/min | 5/8" | 12.02 lbs | AL-310 |
Where Each Product Wins
The Uimoso's Z-axis naming makes it the direct partner for Z-axis feed work. The VEVOR's X-axis naming makes it the direct partner for X-axis feed work. That distinction matters more than the small differences on paper because a power feed intended for the wrong axis won't suit the task. Neither unit is a universal replacement, so the axis you need to automate should be your first checkpoint.
Product Notes
Z-Axis Power Feed Table Mill for Milling Machine 450 in-lb Torque 0-200RPM
The Uimoso's title names the Z-axis, making it the natural candidate for Z-axis feed projects. Its model number is AL-450, and its listed net weight is 12.57 lbs. If your milling machine needs power feed on the Z-axis, this unit lines up with that job without any ambiguity about which axis it serves. The main limitation is orientation: because this is a Z-axis unit, it won't be the right choice for an X-axis table feed. Also, at 12.57 lbs, it lists a bit more weight than the VEVOR's 12.02 lbs, so if you're tracking the added load on your machine, that half-pound difference may matter in a tight setup.
VEVOR X-Axis Power Feed Table Mill for Milling Machine 450 in-lb Torque 0-200RPM
The VEVOR is the pick when the feed work happens on the X-axis. Its model number is AL-310, and its listed net weight comes in at 12.02 lbs, which is slightly lower than the Uimoso's figure. When your mill calls for X-axis power feed, the VEVOR's naming gives you a clear fit and takes the guesswork out of the selection. The limitation is the reverse: the VEVOR is named for X-axis use, so it's not suited to Z-axis feed. If your machine needs Z-axis automation, you'll want the Uimoso instead. For that reason, axis direction is the real tiebreaker between these two.
Final Pick by Use Case
Pick the Uimoso Z-Axis if your feed task is on the Z-axis. Pick the VEVOR X-Axis if the feed goes on the X-axis. Since the two power feeds are so close in listed performance, your final call is about which axis you're automating rather than a meaningful performance gap.
